Inhaltsverzeichnis
Werbung
Seamax Portable12V SUP-20D Electric Air Pump for Inflatable SUP, Kite and Inflatable Boat
FAULT
The air pump
1. The power source is not
cannot be started
plugged properly.
normally.
2. The fuse in DC plug (7) is
burnt out.
3. Overheating or overload.
Slow or abnormal
1. Check whether the hose is
inflation.
blocked or cracked.
2. The joint between the
hose and air pump or
inflatable product is not
installed properly.
3. Make sure the power
source meets the pump's
requirements 12V 15A
▪
This pump is suitable for the products with HR (Halkey-Roberts), Bravo or similar air valve. They are the most popular air
valves for the inflatable SUPs and paddle boards in the current market. This type of air valve has a center turning pin (HR
valve) or pushing pin (Bravo) control the air valve's Open / Close position. The universal valve adapter supplied with the
pump shall fit it.
▪
Please make sure the air valve is in its Close position when inflating the air chamber. Otherwise, some air may leak from
the valve when the air hose is being disconnected. Our air pump comes with universal HR valve adaptor with 3 different
thickness Silicon Rubber O-Rings (3mm/5mm/6mm ). The 6mm O-ring is per-installed on the air hose valve adaptor. It
should have one to fit your air valve best and air tight.
▪
If you cannot use our valve adapter for your inflatable product, you may have to cut the hose to install yours from the
original manual pump. You can use the electric tape to ensure the diameter fit and tight. You can also contact with
Seamax Marine to apply a set of Free Air Hose for this modification.
INSPECTION
1. Make sure the connect to the 12V DC socket.
2. Change the fuse.
3. Take off the Sand Cap from the pump intake or outtake. Cool
the motor and restart it. Turn on the pump in the air to force it
fast cool down.
1. Change the hose or make it unblocked, and check whether the
hose is cracked.
2. Reinstall the hose or valve adaptor, put the right size O ring
3. If the problem cannot be solved, please contact with the
manufacturer or its service agent or the similar authorized
personnel.
4. Do NOT use compact AC to DC wall convertors to power the
pump. Connect the pump car charger adapter directly to a car's
charger socket. Or use a well charged minimum 12V 7AH external
lead acid battery with the optional 12V battery connector.
AIR VALVE CONNECTION
Page 12
www.seamaxmarine.com 1877-907-7766
SOLUTION
Werbung
Inhaltsverzeichnis
