Inhaltsverzeichnis
Werbung
Seamax Portable 12V SUP-16DB Electric Air Pump with Built-in Lithium Battery
for Inflatable SUP, Kite and Inflatable Boat www.seamaxmarine.com 1877-907-7766
Air Valve Connection
▪
This pump is suitable for the products with HR (Halkey-Roberts), Bravo or similar air valve, which are the
most common air valves used in the inflatable SUPs and paddle boards. This type of air valve has a center
turning pin (HR valve) or pushing pin (Bravo) to control the air valve's Open/Close position. The universal
valve adapter supplied with the pump shall fit this type of air valve.
▪
Please make sure the air valve is in its Close position when inflating the air chamber. Otherwise, some air
may leak from the valve when the air hose is being disconnected.
▪
The air pump comes with a universal HR valve adaptor with 3 different thickness Silicon Rubber O-Rings
(3mm/5mm/6mm). The 6mm O-ring is per-installed on the air hose valve adaptor. There should be one
provided to fit the air valve best for air tight result.
▪
If the provided valve adapter doesn't fit for your inflatable product, you may consider to cut the hose from
the original manual pump. Electric tape is strongly recommended to be used to ensure the diameter fit and
tight.
Maintenance and Storage
▪
To move, maintain, or adjust the product, first pull out the DC plug from the socket.
▪
Clean all dirt from the pump, and let it fully cool down after use, and then store it in a dry and ventilated
place.
▪
The pump shall not be exposed to the rain or immersed in water. But if it gets wet, let it dry in the air before
packing it into the carrying bag.
▪
Best to store the pump in the temperature range between 5º C and 20º C (37º F to 52º F).
▪
The pump is best stored when the battery is 50 - 80% full.
▪
Turn the pump's power off after each use and before storage.
Page 6
Werbung
Inhaltsverzeichnis
