Chap 4 Using The Machine; Key And Symbols; Switching The Dishwasher On; Filling The Rack - ACKERMANN BA U 530 Bedienungsanleitung

UK
Referring to Fig.1:
1 ON/OFF BUTTON
2 PROGRAMME SELECTION BUTTON
3 START BUTTON
Referring to Fig.2
•
Turn on the main power switch and open the external water tap.
•
Check the presence of the overflow.
•
Press ON/OFF (1).
•
Loading begins automatically when the machine is switched on.
•
The point on the display flashes until the level is reached.
•
The STATUS BAR (5) lights up from the top downwards to indicate that the dishwasher is heating
up.
•
When the working temperature is reached, the central led on the STATUS BAR (5) stays on, fixed.
•
The optimal wash conditions have been reached. This can take up to 45 min.
Fig. 3
Referring to , to ensure the correct operation of the dishwasher follow the rules described below:
•
Use a suitable rack, fill without overloading and without overlapping the dishes.
•
Always wipe the dishes before placing in the dishwasher; do not put dishes with dry or solid
residues in the washer.
•
Place the empty dishes in the rack facing downwards.
•
Place plates and the like in the sloping rack, with the inner surface facing upwards.
•
Place the cutlery in the cutlery basket, handle end down.
•
Do not place silver and stainless steel cutlery in the same cutlery basket as this will turn the silver
brown and may corrode the steel.
•
Wash the dishes immediately after use, in order to prevent any residue from hardening and sticking
on them.
•
Use only solid, dishwasher-proof dishes.
•
Press the PROGRAMME SELECTION button (2) repeatedly to select a wash cycle that is suitable
for the dishes to be washed; the display will show the cycle number chosen (Fig. 4).
•
To run the programme, press START (3); the STATUS BAR (5) starts to flash, increasing from the
bottom upwards to indicate the progression of the cycle.
•
When the cycle is completed, all the leds will come on, fixed ( Fig.5 ).
•
For rapid drying, remove the rack from the machine as soon as the cycle finishes.
•
To stop a wash cycle early, press START (3).
N.B. In hood versions, after the first work cycle the automatic start is automatically enabled; the
subsequent cycles will be enabled automatically when the hood is closed. This operating mode
is marked on the display by "AS".
Page 6 of 12
INSTRUCTION MANUAL FOR DISHWASHERS

Chap 4 USING THE MACHINE

4 DISPLAY INFORMATION
5 STATUS BAR (LED)
4.2

Switching the dishwasher on

4.4

Cycle selection and start-up

4.1 Key and symbols

4.3

Filling the rack