Dimol Mini 01 Handbuch Seite 18

• When removing the plug power from outlet, not pull
by the wire - hold the plug.
• If the appliance is not in use, disconnect it from the
network.
• During operation, keep the wire to does not touch
the heating surface.
• Do not hide wires under the carpet, do not place on
top mats, carpets etc. Place the wire so as not to trip
over it.
• Leave the appliance for storage sites if it is hot.
• Do not leave the device unattended in a room where
there are children or disabled.
• For safety reasons are not recommended to use the
appliance physically or mentally defective people if by
responsible persons have not provided them with the
necessary instructions for of exploitation the
appliance or in the use of electrical equipment
unsupervised.
• Do not let children play with the appliance.
• All surfaces of the device designed to prevent direct
access to heating elements and must be in their
places during operation.
• To prevent overheating, do not cover the heater.
• Damaged cord must be replaced by a qualified
electrician to avoid accidents.
• Use this appliance is only for its intended purpose
by the present leadership. Any other use are not
recommended by the manufacturer.
General data and purpose
The present Manual applies the following models of
electrical panels Dimol (hereinafter referred to the
panel heater): Mini Plus 01, Mini 01 with thermostat,
Mini 01, Standart Plus 03, Standart 03 with
thermostat, Standart 03, Maxi Plus 05, Maxi 05 with
thermostat, Maxi 05, Standart Plus 07, Standart 07
with thermostat, Standart 07, Mini 02.
Electrical panels Dimol is a product of Ukrainian
engineers combines two different methods of heat
transfer. The uniqueness of the device is that this
heater can operate as long-wavelength infrared heater
and convection heater.
• The obverse (front) part of heater is a source of long-
wave infrared radiation, which favorably affects the
human body and creates a feeling of comfortable
warmth.
• In inside of the heater embedded the heating
element of closed type, providing a heating of room
and does not burn oxygen.
• Heater belongs to the modern class of stationary
products of electric heating of residential buildings
and administrative buildings and can be installed
both indoors with normal environment and in areas
with high humidity.
• Heater is designed for unattended operation around
the clock, as the basic element of stationary electric
heating with centralized automatic control of room
temperature (hereinafter - the system), but can be
used as an additional source of local heating.
EN
17
• Heating system achieves the most uniform
distribution throughout the volume of the room
comfortable heated air to warm up the lower portion
of the room.
• To improve the efficiency of the system are
encouraged to apply tools for automatic temperature
control in the room (if there is no built-in control).
• Possibility to use as an a wall (the installation of
mounting brackets), and a floor version (legs with
rollers).
• When buying the device check that supplied section
"Completeness" of the Guidelines, no mechanical
damage, presence warranty and pull (vouchers)
passes, completeness and correctness of their filling.
Warranty Certificate is valid only at presence correctly
and legibly indicated sales data, clear stamps of firm-
seller. After filling out the warranty card not make to
him any amendment, supplement, delete and rewrite
data recorded by the Seller. Keep the cashier's check,
this manual, warranty card during the warranty
period. Lost documents attached to the sale
convector, not restored.
• Remember, when non-compliance listed above
recommendations, in the presence of mechanical
damage, you lose the right to warranty service.