Possible Malfunctions; Waste Disposal - CombiSteel 7077.0100 Gebrauchsanweisung

7. POSSIBLE MALFUNCTIONS

In case of failure turn the device off with the main switch and disconnect the device from the power supply (pull
the plug!). Before calling the technician or informing the vendor check the possibility of removing the failure by
yourself according to the table below.
Failure Possible reason
No cooling • Improperly connected plug.
• The machine is not switched on.
• Fuse of the circuit tripped.
• Loss of electrical power.
• Temperature regulator damaged.
Insufficient cooling • Improper temperature setting.
capacity • The device is in the thawing process.
• Too close location to sources of heat or
direct sunlight
• Poor air circulation around the device.
• Device overloaded.
Device emits loud • Loose parts or screws in the device
sound. • Device is placed on an uneven surface.
• Housing of the device is touching the
wall or other devices.
When the anomalies cannot be removed:
- do not open the housing,
- contact the service company or the vendor, and specify:
o
failure type;
o
Code number and serial number (see: type plate on the right side of the device).

8. WASTE DISPOSAL

Discarding old devices
At the end of its service life the discarded device has to be disposed in accordance with the national regulations.
It is advisable to contact a company which is specialized in waste disposal, or just contact the local disposal
service in your community.
WARNING!
To exclude any abuse and the dangers involved make the waste device unfit for use before
disposal. For that purpose disconnect device from mains supply and remove mains connection
cable from the device.
CAUTION!
For the disposal of the device please consider and act according to the national and local rules and
regulations.
Solution
• Unplug the plug and reconnect it
correctly.
• Turn on the device with the ON/OFF
switch.
• Check the fuse, check the device when
connected to a different socket.
• Check power supply.
• Contact the seller.
• Correct temperature setting.
• Wait until the thaw phase is complete,
check the cooling performance.
• Ensure sufficient distance from sources
of heat.
• Cool groceries before placing in the
machine.
• If necessary, remove some items from
your device.
• Tighten loose parts or screws in the
device
• Place the device on an even surface.
• Ensure sufficient distance from the wall
and other devices.
www.combisteel.com
15