Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.1.3 Installation
Positioning
•
Place the device on a firm, dry, level and waterproof surface adapted to the impact of high temperatures
and sufficient load-bearing capacity for the weight of the device including the entire contents.
•
Never place the device on flammable surfaces.
•
Do not place the device in the vicinity of an open flame, electric ovens, heating stoves or other heat sources,
such as direct sunlight. High temperatures may adversely affect cooling performance and power
consumption.
•
Place the device in such a way as to ensure proper circulation of air. Never cover or block ventilation holes
of the device.
•
Do not place the device in places with high humidity. Excessive moisture may damage the device. Optimum
working conditions of the device are in the ambient temperatures between 10°C and 30°C and with relative
humidity of 30 - 55%.
•
Do not use doors, door handles and other protruding parts of the device as the support during
transportation. Move the device only by lifting it with appropriate transport device (e.g. forklift), to avoid
damaging feet or other components.
•
After arranging the device at the desired place, tighten/loosen the adjustable feet until the device is standing
straight.
•
Before the first use, remove the protection foil from the device. Remove it slowly to ensure no glue residues
remain. Remove possible glue residues with appropriate solvent.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the device if the need arises.
Connection
DANGER! Risk of electric shock!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should be compared with
that of the device (see rating plate). Connect the device only in case of compliance! Connect the
device only to properly installed single socket with protective terminal.
•
If the device was transported in vertical position, wait 2 hours before connecting the device to the power
supply (embedded condenser).
•
After a power failure or if the plug is removed, the device should not be connected to the power supply for
at least 5 minutes.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the device directly to the
wall socket; do not use any extension cords or power strips.
www.combisteel.com
10
Werbung
Inhaltsverzeichnis
