Philips HD4466 Bedienungsanleitung Seite 11

Problem Possible cause
Food or grease has caked onto
the grilling plate.
The food is not You have set a too low or too
grilled properly high temperature and/or you
(too raw or have grilled not grilled the food
burnt). long enough or you have grilled
it too long.
During grilling, fat You have not put the drip tray in
or juice drips the base.
onto the
worktop
During grilling, fat You have not put the splatter
or juice splatters guard on the appliance.
onto the
worktop
You are grilling ingredients that
contain a lot of fat or juice.
The table grill The table grill has been on for
switches off in more than 45 minutes. If you do
the middle of the not use the + and - buttons to
grilling process adjust the temperature or the
timer for 45 minutes after you
switch on the appliance, the
appliance switches off
automatically for safety reasons.
The message 'Err' The appliance is unable to reach
appears on the the set temperature and
display. therefore the heating element
switches off.
Solution
Carefully clean the grilling plate after each
use. You can remove residues by soaking
the plate in hot water with some washing-
up liquid for five minutes. This will loosen
any caked food or grease.
Set a lower or higher temperature and/or
grill the food for a longer or shorter
period. See the table at the end of this
booklet for the recommended
temperature and grilling time for various
types of food.
Put the drip tray in the base.
Put the splatter guard on the appliance.
Clean the worktop with a damp cloth
after grilling.
To continue cooking, you have to press the
temperature/timer button or the + or -
button.
Unplug the appliance and let it cool down.
Then put the plug back into the wall
socket, switch on the appliance and let it
heat up again. If the message 'Err' appears
on the display again, contact
the Consumer Care Centre in your
country.
EnglisH
11