Ec Declaration Of Conformity - Makita LF1000 Betriebsanleitung

Replacing carbon brushes (Fig. 73 & 74)
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
After use
• After use, wipe off chips and dust adhering to the tool
with a cloth or the like to assure maximum service life.
Keep the blade guards clean according to the direc-
tions in the previously covered section titled "Blade
guard". Lubricate the sliding portions with machine oil
to prevent rust.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Steel & Carbide-tipped saw blades
• Vertical vise
• Socket wrench 13-3
• Dust bag
• Triangular rule
• Dust cover (Lower blade guard C)
• Push stick
• Ruler assembly (Rip fence)
• Miter gauge
• Fix plate (3 pieces)
• Hex bolt (3 pieces)
• Elbow
• Top cover assy (Top blade guard)
26
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 92 dB (A)
sound power level:
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN61029.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in compliance with the following standards of standardized
documents,
EN61029, EN55014, EN61000
in accordance with Council Directives, 73/23/EEC, 89/
336/EEC and 98/37/EC.
Certificate of adequacy of the technical file with respect
to 98/37/EC having been obtained from the following
notified body:
Intertek SEMKO AB, Torshamnsgatan 43, Box 1103, SE-
164 22 Kista, Sweden
Yasuhiko Kanzaki CE2004
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
105 dB (A)
2
.
Director