Chicco HUMI AMBIENT Gebrauchsanleitung Seite 31

Lukewarm Steam Humidifier
Humi Ambient
WARNING!
Read the safety instructions at the begin-
ning of the manual.
Humi Ambient is the new lukewarm steam
humidifier by Chicco with a compact, harmoni-
ous design that ensures daily well-being and a
healthy environment for the whole family. The
steam helps re-establish the correct level of hu-
midity in heated environments or in rooms with
air conditioning, preventing dry air from form-
to maintain the natural protective mechanisms
of the nasal mucosa and the membranes of the
respiratory tract, providing greater protection
from bacteria and polluting particles.
CONTENTS
Humidifier
Instruction manual
COMPONENTS OF THE UNIT (FIG. A)
1. Essence holder
2. Water tank
3. Steam outlet
4. Steam duct
5. Power cable with plug
6. Technical base
7. Ventilation opening filter
8. Lid
9. Set of magnets (not removable)
10. On / stand-by button
and steam intensity regulation
11. Led
12. Heating plate
13. Heating tank
14. Cap
15. Tank handle.
16. Air duct
17. Steam duct lock
INSTRUCTIONS
Preliminary operations
intact and that the power cable (5) is not
plugged into the mains socket.
Remove the lid (8) from the water tank (2)
ly using the handle provided (15).
[not excessively cold or at room temperature].
(Fig. C) Make sure that the steam duct (4) is
correctly positioned in the heating tank (13),
Screw the tank cap (14) on fully and again put
the water tank on to the heating tank.
balsamic oil or essences to the essence hold-
er (1) (Fig. B)., ensuring that the balsamic oil
or essence does not come into contact with
the external surfaces of the water tank (2)
or penetrate the device through the steam
outlet (3), as this could irreparably damage
the device and the water tank (2).
Always install the device as indicated in
the SAFETY WARNINGS paragraph of this
manual.
ON / STAND-BY MODE
et that is only easily accessible by an adult.
electricity network, the device will issue a
warning signal ("beep") and the LED (11) will
light up green for approximately 2 seconds,
after which the LED will become red and the
device will remain in standby mode.
LED will remain on with a constant red light
and the heating element, ventilation system
and steam intensity regulation function will
not be activated
tains enough water, when the switch (10) is
pressed for more than 2 seconds, the hu-
midifier switches on in "low steam intensity"
mode, the LED (11) turns green and the wa-
ter in the heating tank (13) begins to heat
up. By turning the switch (10) clockwise,
"high steam intensity" mode is activated and
the green Led becomes brighter.
31
-
-
-