Using The Remote Control Unit - Technibel Climatisation REVE 245CH2O Installationsanleitungen

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote control
●
unit.
Insert two AAA alkaline batteries of 1,5 V-DC.
●
Make sure the batteries point in the direction marked
EG
in the battery compartment.
The batteries last about six months. Depending on how
●
much you use the remote control unit.
Remove the batteries if you do not use the remote control
unit for more than one month.
Press the +, -, SET and CLEAR buttons together after
batteries replacement.
(This operation allows you to reset correctly all the
programs. The remote control unit is to be set up again).
Replace the batteries when the remote control unit lamp
fails to light, or when the air conditioner does not receive
the remote control unit signals.
The batteries of the remote control contain polluted
●
substances exhausted batteries must be disposed
according to the laws in force.
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature is detected
●
and checked by the temperature sensor placed in the air
conditioner.
Press the remote control I FEEL button to activate the
●
temperature sensor placed in the remote control. This
function is designed to provide a personalised environment
by transmitting the temperature control command from the
location next to you. Therefore, in using this function, the
remote control should always be aimed, without
obstruction, at the air conditioner.
REMOTE CONTROL UNIT
RECEIVER
TRANSMITTER
HEAD
9
NOTE
The remote control unit sends
the temperature signal to the
air conditioner regularly at two
minute intervals. If the signal
from the remote control unit
stops for more than five
minutes due to some troubles,
the air conditioner will switch to the temperature sensor
which is built into the unit and controls the room
temperature. In these cases, the temperature around the
remote control unit may differ from the temperature
detected in the air conditioner position.
OPERATION WITH THE REMOTE CONTROL UNIT
CAUTION
Check that the circuit breaker on the power panel is turned
ON and that the standby lamp is light up.
When using the remote control unit, always point the unit
transmitter head directly at the air conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air conditioner on.
The operation lamp will light up, indicating the unit is in
operation.
REMOTE CONTROL UNIT
DISPLAY
UNIT