simu 5009114E Handbuch Seite 7

Location of the "Prog" key on Hz transmitter:
i
Hz long range " transmitter
Hz wall transmitter
Programming the first individual control point
5
5.1 5.2
Programming a new control point
6
- Individual control point
6.1
6.2
- If your new control point is a group control : perform operations 6.1 and 6.2 for each motor of the group.
- If your new control point is a general control : perform operations 6.1 and 6.2 for each motor of the
installation.
- To delete a transmitter from the memory of a receiver, perform operations 6.1 with a programmed indivi-
dual transmitter and 6.2 with the transmitter to be deleted.
Hz 1/5 channels
transmitter
- New control point
Hz Timer
3 / 4