Haier HW70-B14266 Gebrauchsanleitung Seite 5

Control panel -
function buttons
To get best results in each programme Haier has well defined specific default settings.
If there is no special requirement default settings are recommended. Accordingly to
these factory settings many programme parameters and additional functions could be
individually changed (see "programmes" and "function" buttons).
"Function" (button a)
Speed up
Touch it to select sequentially required functions and set-
Intense
tings. The related function name and setting will shine.
Soak
Anti crease
- "Speed up" : Saves time and energy. Preferable if laundry
is slightly soiled.
Rinse
- "Intense" : Intensifies cleaning results. Preferable if laundry
Function Selection Temp. Spin Speed
is heavily soiled.
- "Soak": Laundry will remain in last rinse cycle water.
- "Signal"
a b
- "Rinse+" : Adds 1-3 rinse cycles. Preferable to better flush
out possible residues
"Selection" (button b)
Touch it to confirm the current shining "Function", its sym -
bol is blinking. Additionally a "checkmark", or a "1"/"2"/"3"
will light up. Function will be activated after 3 seconds or
if "Function"(button a) is touched, all related symbols are
shining.
"Child lock" - control panel lock function
(button a + b)
This option blocks all panel elements against activation. After
starting, press si m ultaneously "Function"+"Selection" for about
3 seconds. Panel lock symbol is now displayed. Next repetition
deblocks any function.
Speed up
Intense
"Temperature" (button c)
Soak
Touch it to adapt maximum of water temperature.
Anti crease
Note: Display of
Rinse
Temp. Spin Speed M emo Delay
"Spin Speed" (button d)
Touch it to adapt speed of centrifugation.
c d
Note: Display of "
M emo Delay
: Activates the signal tone mode .
"
" stands for no operational heating" .
" "
" stands for "no operational spinning ".
8 9
"Memo" (button e)
Touch it for 2 seconds to memorize all currently displayed
settings as to-be default settings. Two signal tones confirm
that change. When programme is started or chosen next
these settings are activated.
"Delay" – Start time delay (button f)
Touch it to increase programme start time in steps of 30
minutes from 0,5-24h. Related symbol and current start time
will light up. During operation at first countd own of delay
time and subsequently remaining programme cycle time will
be displayed. Related symbol will shine.
General information and tips:
To cancel any actual setting change programme or press
"On/Off " about 3 seconds. To cancel a running program
me touch "Start/Pause" and then "On/Off " for about 3
seconds.
Display symbols
Basic status indication
Door is locked
(in operation)
Control panel locked
No water supply
Door is open
.
Control panel
function buttons -
Speed up
Intense
Soak
Anti crease
Rinse
Function Selection Temp. Spin Speed M emo
e
-
Programme cycle Programme settings
indication
Running wash No operational
cycle heating
Running rinse No spin cycle
cycle
Running spin/ Memo
drainage cycle
Time display Delay
(1 or 2)
Remaining operation time (1)
Remaining delay time (2)
Delay
f