Attaching The Cable Cover - Dell OptiPlex SX System Installierung Und Schnellreferenzhandbuch

Connecting a VGA Monitor
If you have a VGA monitor and a DVI connector on the back of your computer, plug the
VGA-DVI adapter into the DVI connector and connect the monitor cable to the adapter
as shown.

Attaching the Cable Cover

6
NOTICE: If you are installing the computer under a desktop or tabletop, do not attach the
cable cover until the computer is firmly attached to the mounting plate (see Step 7, "Attaching
the Stand to the Mounting Plate" on page 19).
NOTICE: If you use the stand on your computer, attach the stand before attaching the cable
cover.
NOTICE: When attaching the cable cover, do not place the computer face-down so that the
surface comes in contact with a hard surface. Doing so may press the power button and may
scratch the face of the computer.
Attach all of the cables to the back of the computer.
1
Hold the bottom piece of the cable cover and align the four tabs with the four slots
2
on the computer's back panel.
Insert the tabs into the slots and slide the piece toward the diagnostic lights
3
(see the illustration) until it is securely positioned.
Setup and Quick Re ference Guide
17