Setting The Viewing Position; Use; Display Settings; Menu Functions - Silvercrest KH 6500 Bedienungsanleitung

6.5 Setting the viewing position

Your portable DVD player is equipped with a
pivoting swivelling TFT display screen.
In the event that you find the image quality of a
DVD to be insufficient, slightly turn the device to op-
timize the viewing angle.
The TFT display screen will turn 180° and fold
down in this position thus allowing the display to
operate when the device is closed up.

7. Use

• Carry out the required connections as described
in chapter 5 and provide a power supply.
• Lift up the TFT display screen.
Switching the DVD player on and off
POWER
• Set the switch to the "ON" position
to switch the DVD player on.
The TFT display screen switches on and the back-
ground image appears.
If no disc is inserted into the disc tray the notice
"READING" will appear briefly followed by the
prompt "NO DISC".
• To switch the DVD player off set the
to the position "OFF".
Buttons on the device and the remote control
Most of the functions described in this manual can
be set using the buttons on the device or also the
buttons on the remote control. When both buttons
are possible for operation then both numbers will
be specified after the button designation (for exam-
DVD/USB/CARD
ple button.

Display settings

FUNCTION
• Press the button to access the display
settings. The settings can be accessed at any
time.
• Select with the navigation buttons
the inputs Brightness (Bri), Contrast (Con) and
Saturation (Sat).
• With the navigation buttons
lue.
• To exit the settings press the
again.
• To reset the settings select the input Reset and
press the button

8. Menu functions

Navigating in the menu

1. Press the
The main menu appears GENERAL SETUP
PAGE.
• With the navigation buttons
button
the menu.
* * GENERAL SETUP PAGE * * * * GENERAL SETUP PAGE * * * * GENERAL SETUP PAGE * *
TV DISPLAY TV DISPLAY TV DISPLAY
ANGLE MARK ANGLE MARK ANGLE MARK
OSD LANGUAGE OSD LANGUAGE OSD LANGUAGE
CLOSED CAPTIONS CLOSED CAPTIONS CLOSED CAPTIONS
SCREEN SAVER SCREEN SAVER SCREEN SAVER
LAST MEMORY LAST MEMORY LAST MEMORY
POWER
switch
GOTO GENERAL SETUP PAGE GOTO GENERAL SETUP PAGE GOTO GENERAL SETUP PAGE
2. With the navigation buttons
menu by moving the yellow highlighting under
the corresponding menu symbol.
3. With the navigation buttons
input in a menu by moving the yellow bar over
an input.
4. With the navigation button
input in the sub menu and with the navigation
button
level.
5. To confirm a selection press the button
• All navigation possibilities in a current menu are
one of displayed at the lower edge of the menu.
• To exit the setup menu either press the button
SETUP
press the button
- 86 -
FUNCTION
OK/ENTER
.
SETUP
button to access the setup menu.
OK/ENTER
you can carry out all settings in
WIDE WIDE WIDE
OFF OFF OFF
ENG ENG ENG
OFF OFF OFF
ON ON ON
OFF OFF OFF
you move back to the previous menu
or select the last symbol "EXIT SETUP" and
OK/ENTER
.
change the va-
button
and the
you select a
you select an
you change an
OK/ENTER
.