Do not use the device with wet hands.
●
Place the scanner and its AC adapter near an electrical outlet where the AC adapter can easily be
●
unplugged.
●
ACHTUNG:
Position the AC power cord in such a way to avoid abrasions, cuts, fraying, crimping, and kinking. Do not
●
place objects on top of the AC power cord, and do not allow the AC adapter or the AC power cord to be
stepped on or run over. Be particularly careful to keep the AC power cords straight at the ends, and at the
point where they enter the AC adapter.
The AC adapter is designed for use with the scanner with which it was included. Do not attempt to use it
●
with other electronic devices unless specified.
Use only the type of power source indicated on the product's label.
●
When connecting this product to a computer or other device with a cable, ensure the correct orientation of
●
the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong
orientation may damage both devices connected by the cable.
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and
●
off.
If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged
●
into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating
of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.
Never disassemble, modify, or attempt to repair the AC adapter, scanner, or scanner option by yourself
●
except as specifically explained in the scanner's guides.
Do not insert objects into any opening, as they may touch dangerous voltage points or short-out
●
components. Beware of electrical shock hazards.
If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are fuses in the
●
plug, make sure you replace them with fuses of the correct size and rating.
Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel under the
●
following conditions:
The AC adapter or plug is damaged.
–
Liquid has entered the scanner or the AC adapter.
–
The scanner or the AC adapter has been dropped, or the case has been damaged.
–
The scanner or the AC adapter does not operate normally, or exhibits a distinct change in
–
performance (do not adjust controls that are not covered by the operating instructions).
Unplug the scanner and the AC adapter before cleaning. Clean with a damp cloth only. Do not use liquid or
●
aerosol cleaners.
If you are not going to use the scanner for a long period, unplug the AC adapter from the electrical outlet.
●
Zulassungshinweis für die Europäische Union
DEWW
Be sure the AC power cord meets the relevant local safety standards.
Gesetzlich vorgeschriebene Angaben
27