Troubleshooting - Fp International Pro Pak’r Original Bedienungsanleitung

3 o
perAting
3.8 t
rouble
Trouble
No power to Pro
Pak'r machine
Film won't run
Cushions are flat,
do not hold air
Film jams fre-
quently
Machine stops
automatically
FP International
i
nstructions
s
hooting
Possible Problem
Power cord unplugged
Power switch OFF
Toggle switch OFF
Fuse is blown
Display cover open
Film roll installed back-
wards
Non-FPI film installed
No RFID signal
Air fill tube not inside film
Air pump not working
Seals leaking
Too much air fill
Blade is dull
Backing wheel are worn
Fill tube is worn
Cone tip is worn
Jam sensor not responding
Length Control set to
continuous
Solution
Plug power cord into Pro Pak'r and outlet
Turn power switch ON
Turn toggle switch ON
Replace Fuse on power inlet
Tighten display cover screw with screwdriver
Turn film roll around
Install FPI film roll
Turn roll, if not responding contact FPI for as-
sistance
Reload film onto fill tube
Contact FPI for assistance
Adjust seal temperature or clean backingwheel
Reduce air fill
Replace / reverse / or slide the blade.
Replace or clean backingwheel.
Replace fill tube.
Replace cone tip
Contact FPI for assistance
adjust length control. See page 20.
pro pak'r User Manual Version 1.0 page -25-