Cleaning; Transport/Storage; General; Storage - Fp International Pro Pak’r Original Bedienungsanleitung

3 o
perAting
3.4 c
leAning
As a rule, the machine does not need to be cleaned.
If required, the outside may be wiped down using a damp cloth and soapy water.
3.5 t /s
rAnsport
3.5.1 g
enerAl
The machine is fitted with castors to allow it to be moved rapidly from one workplace to
another. The castors are only suitable for short distances over level, hard factory floors.
3.5.2 s
torAge
No special instructions apply to storing the machine. A cool and dry area is the most suitable
environment for this purpose.
If the machine has been stored or idle for a length of time, it should be inspected by
maintenance personnel before being taken back into use.
3.6 c
ommissioning
The machine is ready for use ex-factory and does not require any installation. Its first use,
however, should be monitored by a technician, as should the first operating session following
a major overhaul or long term storage.
Pay special attention to the following:
• Is there any damage (e.g. incurred during transport),
• Has the machine been set-up correctly (see page 16)
• Does the mains voltage conform to the rating on the identification plate (Page 27)?
• Are all moving parts (feed rollers) free?
Commissioning will generally be carried out by a specialist appointed by the manufacturer or
distributor
pro pak'r User Manual Version 1.0
i
nstructions
Warning!
• During cleaning, the machine must be switched off.
• Electrical components should not come into contact with
water or other liquids.
torAge
page -22-
FP International