FP International PRO PAK’R Original Bedienungsanleitung Seite 20

3 o
perAting
3.3.2 c
hAnging
t c
emperAture
Press the button below the (
•
If the air cushions become flat, and upon inspection the heat seals are leaking air,
increase the Temperature Control by pressing the button below the "+" icon
•
If the air cushions become flat because the seals are burned through at the seal line as
evidenced by holes in the air cushions, decrease the temperature control by pressing
the button below the "-" icon
Press the button below P to accept
After changing the temperature control setting, the PRO PAK'R may take a few moments to
establish the new seal temperature.
During heat-up or cool down, RED LED will flash until the correct temperature has been
achieved.
If air cushions continue to show poor seals and produce flat cushions, contact FPI for assis-
tance.
A c
ir ontrol
Air Control regulates the amount of air in the Air Cushions.
Press the button below the (
If you want to increase the fill level, press the button below the "+"icon
If you want to decrease the fill level, press the button below the "-" icon
Press the button below P to accept
A l
dJust ength
Length control sets the length of a string of air cushions to be pro-
duced each time you press the start button. You have 2 options:
c m
ontinuous
Length control at the factory is preset at continuous production. Press start button and the
machine will run the film until the film roll is empty or the stop button is pressed.
f l
ixed ength
If you want to produce a fixed length of a string of air cushions, press below
Button until desired length is displayed. The machine will count down the length of air cush-
ions produced.
Press P to accept
To change from Fixed to Continuous mode, press - button in the length control menu until
the display shows "0:"
A m
ccess enu
m o
ode ptions
In this option you can select the operation mode, there are 5 option to select
Option 1 Foot Pedal
Option 2: Manually
Option 3: Sensor
Option 4: ADS
Option 5 Auto-Index
Select the desired Mode option. Accept press P .
pro pak'r User Manual Version 1.0
i
nstructions
m s
Achine ettings
ontrol
) to adjust.
) to adjust
c
ontrol
:
ode
page -20-
, press the +
FP International