Display Errors; Moving; Setting Up - Fp International Pro Pak’r Original Bedienungsanleitung

3 o
perAting
r s
estore ettings
Press
In Display shows "Reset all offsets & settings to default / RFID tag
values"
Press P to accept
3.3.3 d
isplAy
If the display shows an error code / symbol, and the red LED flashes, consult the chart below to
determine the cause. Clear the problem as described below, then press START button to resume
normal operation. If the error persists, contact Service Centres at FP International B.v. (See page
3)
Error code
COVER
DELTA T
JAM / FILM END
3.3.4 m
oving
• Switch off the machine.
• Remove film roll from machine
• Unlock the castors and move the machine to the desired place.
3.3.5 s
etting up
Bear in mind the requirements for a workplace. See "Workplace" on page 11.
• Set up the machine on a level surface.
• If the machine is on a stand lock all 4 casters with the integrated locking mechanisms
• Connect the machine to the mains.
FP International
i
nstructions
in the Menu
e
rror
Action
Make sure covers are closed
Contact your distributor or FPI for assistance
In case of jam, open display cover and remove jammed film cafefully
GB: Always remove the roll of film before changing the
position of the stand.
DE : Entfernen Sie immer zuerst die Folie bevor Sie
die Position des Standes änderen.
FR: Retirer impérativement la bobine de film avant de
changer la position du stand.
NL: Verwijder altijd eerst de folie alvorens de positie
van de stand te veranderen.
pro pak'r User Manual Version 1.0 page -21-