Cognex In-Sight 9902L Bedienungsanleitung Seite 13

2. Optionally, connect the I/O wires to an appropriate device (for example, a
PLC, encoder or serial device).
3. Attach the Breakout cable's +24VDC (Red wire) and GND (Black wire) to
the corresponding terminals on the power supply.
CAUTION:
observe the polarity shown.
4. Connect the Breakout cable's M12 connector to the vision system's PWR
connector.
5. Restore power to the 24VDC power supply and turn it on if necessary.
Never connect voltages other than 24VDC. Always
12