Audio Settings - Blackmagic Design Pocket Cinema Camera 6K Installations- Und Bedienungsanleitung

Audio Settings

The 'audio' tab lets you adjust the audio input and monitoring settings on your camera.
The audio settings for the camera are spread over two pages and divided between
channels 1 and 2.
You can map each audio channel to a different source, as well as adjusting various settings
such as gain control.
Audio Settings 1
The first page of the 'audio' tab contains the following settings.
Channel Source
Use the 'channel 1 source' and 'channel 2 source' buttons to select your audio source for each
audio channel. Below is a description of each channel source setting.
‚ Camera Left or Right
Records from your camera's internal microphones.
‚ Camera Mono
Creates a single audio channel from your Blackmagic Pocket Cinema Camera's built in
microphone's left and right channels.
‚ XLR Line
Uses your camera's XLR input to record line level audio.
‚ XLR Mic
Records mic level audio from your camera's XLR input. If phantom power is enabled
and you have your XLR input set to 'mic' you'll also see a '+48V' indicator here. It is also
important to ensure that the 48V switch gets turned 'off' when you disconnect your
phantom powered microphone.
‚ 3.5mm Left – Line
Uses only the left channel of the 3.5mm input as line level audio.
‚ 3.5mm Right – Line
Uses only the right channel of the 3.5mm input as line level audio.
‚ 3.5mm Mono – Line
Creates a mono mix of the left and right channel from the 3.5mm input as line
level audio.
‚ 3.5mm Left – Mic
Uses only the left channel of the 3.5mm input as mic level audio.
Settings 71