Fenix ECOFLEX PREMIER Bedienungsanleitung Seite 13

If you press any button on the keyboard, the display announces, by the symbol "FF", the impossibility to
proceed for any orders.
To remove the keypad lock, operate as above.
This mode permits the automatic operation through a programming unit.
To do this: Press the MODE button until the LED function light "PROG" is on.
Please note that when Economy, Comfort or Anti-Frost MODE is chosen by the user, priority is given to the Anti-Frost and STOP orders sent
by a programming unit. The function light "PROG" flashes orders are received by the appliance.
chosen by user
Exceptionally, it may occur that there is a gap between the displayed temperature and your thermometer. In this case, it is possible to
harmonize the two settings.
This setting can be achieved only if your appliance is set between 17 and 23 °C.
All doors and windows must be closed.
Wait for the stabilization of the temperature in the room (at least 6 hours) and avoid as much as possible whereabouts in the room.
The temperature control should be placed in the middle of the room to 1.20m from the ground. Do not place it on any furniture.
Set the "Comfort" temperature with MODE button, e.g. 19
Push for 6 seconds MODE, this will open two possibilities:
1. Display is flashing 19, a modification is possible:
• Correct with the + and - buttons
• Confirm with MODE
2. FF is displayed, a modification is impossible (if temperature delta is more than 3°C or
the comfort temperature s etting is not within 17°C-23°C):
Note: If no action on + or - for 15 seconds, the display returns to its initial position (19).
« PROG » MODE:
MODE
19
EC
HG
DISPLAYS SETTINGS (THERMOSTAT / THERMOMETER)
PARTICULARITES:
MODE by programmer
Anti-Frost Signal STOP Signal