General Information; How To Use The Refrigerator - Teka TS335 Handbuch

GENERAL INFORMATION

1) Carefully read the instructions contained in this handbook since they provide important
information relative to safety during installation, use and maintenance.
Keep this handbook carefully for future reference.
2) Once the appliance has been unpacked make sure that it is undamaged.
This appliance should be used only for the purpose for which it was specifically designed,
namely for the conservation of foodstuffs.
Any other use is considered unsuitable, and thus dangerous.
The manufacturer declines all responsibility for any damage that may be caused by
unsuitable, incorrect or unreasonable use.
Send off the warranty certificate.
Declaration of compliance: the parts of this appliance that may come into contact with
foodstuffs comply with the provisions of EEC Directive 89/109.
This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes.

HOW TO USE THE REFRIGERATOR

Electrical connection
This refrigerator is set to work at the nominal voltage indicated on the rating plate inside
the product. Voltage fluctuations should not be greater or less than 10% of the nominal
voltage.
Before connecting the appliance ensure that the data to be found on the rating plate is the
same as that of the mains supply. The rating plate is to be found inside the product.
In the case od incompatibility between the socket and the plug of the appliance have the
socket replaced with another suitable one by a qualified electrician, who will also verify
that the capacity of the socket wiring is adequate for the power absorbed by the appliance.
The use of multiple socket adapters and/or extension cables is not recommended.
The supply socket of the refrigerator must be properly earthed. This fundamental safety
requirement must be verified and, if there are any doubts, the installation should be
thoroughly checked by a professional electrician.
The manufacturer declines all responsibility for any damage caused by the appliance not
being earthed.
INSTALLATION
For models where the feet are not already fittet, screw these into the relevant threaded
holes under the refrigerator. Ensure that the two front feet are not quite fully screwed
home, so that the refrigerator leans slightly backwards.
Where applicable, fit the appropriate spacers (fig. 1) in order to obtain proper air circulation
between the refrigerator and the wall behind: it is also recommended not to block any
ventilation or heat dispersal openings or grilles, leaving a space of at least 5 cm.
Do not install the refrigerator close to sources of heat.
Incorrect installation could cause damage to people, animals or things, for which the
manufacturer declines all responsibility.
FUNCTIONAL LIMIT
For best results please ensure that the temperatures where the appliance is installed are
in line with the climate class indicated on the rating plate:
Class N from +16°C
Class ST from +16°C
Class T from +18°C
up to +32°C
up to +38°C
up to +43°C
13