ASROCK 939Dual-SATA2 Bedienungsanleitung Seite 15

2.7 2.7 2.7 Serial A Serial A Serial AT T T T T A (SA A (SA A (SAT T T T T A) Hard Disks Installation A (SA
2.7 2.7 Serial A Serial A A (SA
This motherboard adopts JMicron JMB360 chipset that supports Serial ATAII
(SATAII) hard disk. It also adopts ULi M1567 south bridge chipset that supports
Serial ATA (SATA) hard disks, and supports RAID functions. You may install SATA
hard disks on this motherboard for internal storage devices. This section will
guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
1. If you plan to use RAID 0, RAID 1, or JBOD functions on SATA, SATA
HDDs must be operated in "RAID" mode.
2. "RAID" and "non-RAID" mode are options under "SATA Operation Mode" in
BIOS setup. Please refer to page 30 of "User Manual" in the Support CD for
details. They need different drivers during actual operation.
ASRock 939Dual-SATA2 Motherboard
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
1 5 1 5 1 5
1 5 1 5