Chest Belt; Replacing The Chest Belt Battery; Wearing The Chest Belt; Coded Transmission - Pro 1-LD4497 Bedienungs- Und Sicherheitshinweise

Cleaning and user maintenance of the device may not be performed by children
without supervision. Keep packaging films out of the hands of children. There is a
danger of suffocation.

Chest belt

ATTENTION: Pacemaker patients should consult their physicians before
using the chest belt.

Replacing the chest belt battery

Use a coin to unscrew the battery
cover on the back side of the chest
belt and insert the 3V battery with the
(+) sign facing up. Screw the battery
compartment cover back into the
case.

Wearing the chest belt

Adjust the chest belt so that it fits
snugly directly below the chest
muscles. Moisten the contact areas
with water or ECG gel (ECG gel can
be purchased at a pharmacy).
Ensure that the contact areas
constantly remain in skin contact.
Position the chest belt as per the
following illustration. Please ensure
that the chest belt is seated properly.
When you have exhaled completely
the chest belt should still have very
slight tension pressing it to your chest.
High voltage power lines, Trains or
moving vehicular traffic may interfere
with the heart rate measurement.
Please consider this when planning
your exercise route.
battery CR2032
contact area
- 5 -

Coded transmission

The chest belt's transmissions are digitally coded to prevent interference if you are
training with a training partner who is using an identical watch and chest belt.
When using the chest belt for the first time, a random channel is selected
automatically. The channel is briefly displayed at the top of the display upon
entering the heart rate display mode. The available channels are CH10, CH11,
CH12, CH13 and CH14.
The channel can be changed by briefly removing the battery from the chest best and
reinserting it. The chest belt will randomly select a channel and after approx. 1
minute the heart rate and the new channel will appear on the display of the watch.

Bicycle holder

The included bicycle holder can be used to attach the heart rate monitor to the
handlebar of a bicycle.
Press the bicycle holder onto the top of the handlebar. Handlebars with an
especially large diameter may require the use of additional force to snap on the
bicycle holder. The heart rate monitor can now be attached to the bicycle holder in
the same way that you would attach it to your wrist.
The maximum range of 60 cm between the heart rate monitor and the chest belt
should not be exceeded.
- 6 -