Important Safety Instructions; Before Use; Operation - Makita DX06 Gebrauchsanleitung

• The declared vibration emission value has been measured in accordance with the standard test method and may be
used for comparing one tool with another.
• The declared vibration emission value may also be used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power tool can differ from the declared emission value depending on
the ways in which the tool is used.
• Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time).

IMPORTANT SAFETY INSTRUCTIONS

WARNING! Read all safety warnings and all instructions before operating the attachment. Failure to follow
the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
1. Use the attachment in accordance with these instructions. Use of the attachment for operations different from
those intended could result in a hazardous situation.
2. Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control.
3. Keep work area clean and well lit. Cluttered or dark areas invite accidents.
4. Always wear eye and respiratory protections.

BEFORE USE

Installing or removing the dust collection system
WARNING:
• Always be sure that the tool is switched off and battery cartridge is removed before carrying out any work
on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury from
accidental start-up.
• Before installing the dust collection system, make sure that the attachment points and the power tool itself,
particularly the electrical interface on the power tool, are free from dust and foreign matter. After installing
the dust collection system, also make sure that it is securely installed.
NOTE:
• This dust collection system is intended for use when drilling in only concrete. Never use this system when drilling in
metal or wood.
• This dust collection system collect a significant percentage of the dust produced at work but not all of it.
• Empty the dust case regularly. Failure to empty the dust case regularly may cause dust to release.
• Do not use the dust collection system in core drilling or chiseling applications.
To install the dust collection system, follow the procedure below. (Fig. 1)
1. Hold the power tool so that finger(s) does not press the switch trigger.
2. Align the interface of the attachment with the power tool guide and slide it on the tool until it locks with a double click
sound.
3. After installing the attachment on the power tool, make sure that it is secured properly.
To remove the dust collection system, follow the procedure below. (Fig. 2)
1. Hold the power tool so that finger(s) does not press the switch trigger.
2. Press the release button on the attachment and with the button pressed pull it away from the power tool.

OPERATION

CAUTION:
• Do not use the tool in wet conditions such as work on concrete surface and the similar.
Adjusting the tip protrusion length
The protrusion of the tip is adjustable according to your hammer drill bit length. (Fig. 3)
1. Hold the power tool so that finger(s) does not press the switch trigger.
2. CAUTION: When the stroke adjusting button is pressed, the telescopic section is released and then it may jump out
up to 100 mm under spring pressure. Wear goggles.
Keep the bar tip of the attachment away from any objects keeping the above jumping-out distance in mind and
never point the attachment at yourself, a bystander or animals.
Press the stroke adjusting button and keep pressing it.
5