After Finishing Work; Switching The Vacuum Cleaner Off And Storage; Maintenance Plan - Protool VCP 260 E-M Handbuch

Picking up liquids
Do not pick up flammable substances.
Before liquids are picked up, always remove the
filter bag/waste bag and check that the float
(VCP 260 E-M) or the water level limit (VCP 450 E-M)
works properly. (See section "Replacing the filter
element".)
The use of a separate filter element or filter screen
is recommended.
If foam appears, stop work immediately and empty
the tank.

After finishing work

Switching the vacuum cleaner off and
storage
6. Store the vacuum cleaner in a dry room where it
is protected from unauthorized use.
Maintenance

Maintenance plan

Replacing the waste bag
Replacing the filter bag
Replacing filter element
Replacing filter element
(VCP 450 E-M)
Emptying dirt tank after
picking up liquids
Maintenance work
1. After picking up
Replacing the waste bag
hazardous dust,
Clean the cleaner thoroughly before replacing the
vacuum clean
waste bag – see section "Cleaning the filter element".
the outside of
the cleaner.
2. Switch off the
vacuum cleaner
and pull the
mains plug out
of the socket.
3. Wind up the
power cord and
hang it on the
handle.
4. Empty the tank
and clean the
vacuum cleaner.
5. After picking up
liquids: Store the
upper section of
the cleaner
separately so
that the filter
element can dry.
described in the instructions enclosed.
IMPORTANT: Press the filter bag connection firmly
on to the inlet fitting.
After
finishing
work
During the following work, ensure that dust is
not unnecessarily spread around. Wear a P2
breathing mask.
1. Open the
2. Carefully remove
3. Close the waste
4. Close the waste
5. Dispose of the
6. Insert a new
As
required
•
•
•
•
•
retaining clamps
and remove the
upper section of
the cleaner from
the dirt tank.
the waste bag
connection (1)
from the inlet
fitting.
bag connection
with the slide (2).
bag using the
cable binder (3).
dirt in accor-
dance with legal
regulations.
filter bag into the
cleaned tank as