Sunny SF-E905 Bedienungsanleitung Seite 14

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
STEP 5:
A: Remove the preassembled 2 Spring
Washers (No. 34) and 2 Hex Bolts (No. 35)
from the Handlebar Post (No. 9). Attach
Armrest (No. 31) to the Handlebar Post
(No. 9) in place. Secure it with 2 Spring
Washers (No. 34) and 2 Hex Bolts (No. 35)
that were just removed using Wrench (No.
103), and then pull the Pulse Sensor Wire
(No. 46) out of the Handlebar Post (No. 9).
Finally attach the Decorative Cover (No.
36) onto the Armrest (No. 31).
B: Attach the 2 Handlebars (No. 32L/R) on
the 2 Swing Bars (No. 24L/R) with 4
Carriage Bolts (No. 37), 4 Arc Washers
(No. 14) and 4 Domed Nuts (No. 33) using
Spanner (No. 104).
Note: If the Handlebar (No. 32L/R) rubs
against the Armrest (No. 31) during the
workout please recheck if the Handlebar
(No. 32L/R) is assembled correctly. You
should attach Handlebar (No. 32L/R) to
Swing Bar (No. 24L/R) according to the
label marked with L or R.
STEP 6:
Connect the 2 Pulse Sensor Wires (No.
46) and Upper Sensor Wire (No. 15) to the
Meter (No. 38) respectively. Align the slot of
the Handlebar Post (No. 9) to the bulge
inside the Meter (No. 38) then slide it onto
the Handlebar Post (No. 9) slowly.
Note: To avoid damaging the wires, please
push them into the Handlebar Post (No. 9)
before sliding the Meter (No. 38) onto it.
THE ASSEMBLY IS COMPLETE!
13