Axis 231D+ Installationsanleitung Seite 4

Page 4
Hard Ceiling Mount
Control
button
Network
connector
Connection
module
connector
Power
Indicator
Network
Indicator
Referring to the image above, follow these instructions to mount the dome camera:
1. Using the supplied drill template, drill three holes in the ceiling and secure the bracket to
the ceiling with three screws.
2. Slide the decoration ring and cover ring on to the AXIS 231D+/232D+.
3. Insert the fixing screw holder into the mounting slot.
4. Connect the connection module cable to the
connection module.
5. Connect the Ethernet cable and connection module to
the AXIS 231D+/232D+.
6. Connect the power cable (24V AC) to the connection
module and check that the power and network LEDs
light up green.
7. Mount the dome body onto the bracket and rotate it
clockwise. Make sure the screw hole on the side of
dome is aligned with the bracket. Tighten the fixing
screw to secure the dome.
8. Attach and secure the cover ring and decoration ring
to the bracket.
9. The hardware installation is now complete, proceed to Setting the IP address, on page 7
to install the AXIS 231D+/232D+ on your network.
Rear view
Serial number
AXIS 231D+/232D+ Installation Guide
S/N
Mounting slot for
fixing screw
Side view
Cover ring
Ceiling
bracket
Decoration
ring
Connection module
PS GND
24V AC
Connection module cable connector