Cleaning And Maintenance; Troubleshooting - Concept VV5720 Handbuch

EN
O = unit is switched off.
I = very low air flow
II = very strong air flow
5. Select the desired air temperature using the regulator (7).
I
= low temperature
II = mean temperature
III = high temperature.
6. During drying, style your hair using a comb. Keep a safe distance in order to avoid burning the hair and skin, or
sucking your hair into the inlet grille.
7. The COOL function (flow of cold air) - is used for quick cooling of your hair, and subsequently gives better hold to
the hairstyle. To activate this function, press button (3).
8. When putting down the unit during use, always switch it off.
9. The removable nozzle enables aiming a narrow air stream towards the comb or brush you are using on your hair.
10. Switch the unit off after use.
11. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect it from the
wall outlet, as the proximity of water and any contact of the unit with water are very dangerous, even if the unit is
switched off.
12. The hanging loop enables you to hang up the unit to store it.

CLEANING AND MAINTENANCE

Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
Check the cleanliness of inlet and outlet grilles after each use. If necessary, press the button for releasing of the inlet
grille (8), remove inlet grille, clean it and replace. Never clean the unit under running water, do not rinse it or
submerge in water.

TROUBLESHOOTING

Problem
The motor is not
running.
The motor has stopped
operating.
VV5720
Cause
The plug is inserted into the socket
incorrectly or insufficiently.
The socket is not live.
The supply cable is damaged.
The air flow is incorrect or too low and,
consequently, the motor overheating fuse
has been activated.
Solution
Check the plug connection.
Check to make sure voltage is present, e.g.
by using another appliance.
Refer the unit to an authorized service
centre for testing and repair.
Disconnect the power supply cable
from the socket. Check and clear the air
passage on the inlet and outlet grilles.
Let the unit cool.
19