Cleaning And Maintenance - Concept VV 5730 Bedienungsanleitung

OPERATING INSTRUCTIONS
The unit is designed to dry human hair. Do not use it on wigs or animals.
1. Dry your hair with a towel after washing.
2. Brush your hair. Do not use hairspray or other flammable substances.
3. Uncoil the supply cable. Connect the power cord plug to the wall outlet.
4. Select the desired air speed by the regulator (8).
O = unit is switched off.
I = very low air flow
II = very strong air flow
5. Select the desired air temperature using the regulator (7).
I = low temperature
II = mean temperature
III = high temperature.
6. During drying, style your hair using a comb. Keep a safe distance in order to avoid burning the hair and
skin, or sucking your hair into the inlet grille.
7. The COOL function (flow of cold air) - is used for quick cooling of your hair, and subsequently gives better
hold to the hairstyle. To activate this function, press button (3).
8. When putting down the unit during use, always switch it off.
9. The removable nozzle enables aiming a narrow air stream towards the comb or brush you are using on
your hair.
10. Switch the unit off after use.
11. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect it
from the wall outlet, as the proximity of water and any contact of the unit with water are very dangerous,
even if the unit is switched off.
12. The hanging loop enables you to hang up the unit to store it.

CLEANING AND MAINTENANCE

WARNING!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
Check the cleanliness of inlet and outlet grilles after each use. If necessary, press the button for releasing of
the inlet grille (8), remove inlet grille, clean it and replace.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
VV 5730
EN
25