Stryker Stair-PRO Bedienungsanleitung Seite 18

T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e o o c c c c u u p p a a n n t t u u p p s s t t a a i i r r s s
W W A A R R N N I I N N G G
• Always transport the occupant on stairs with a minimum of two trained operators.
• Always lock the lift handles in position before you use the lift handles to lift the chair.
To transport the occupant up stairs:
1. Roll the chair to the bottom of the stairs with the occupant's back to the stairs.
2. Foot end operator: Push the red release buttons to extend the foot end lift handles and pull the handles out until they
stop. Release the buttons to lock the handles.
3. Head end operator: Unfold the head end lift handles.
4. Foot end operator: Face up the stairs.
5. Head end operator: Face backward to better monitor the occupant or forward for a better view of the stairs and to
maneuver around obstacles.
N N o o t t e e - - Although the head end operator can face either direction while lifting and carrying, always follow any applicable
protocols when you carry the chair.
6. Both operators - Lift the chair together. Use the head end lift handles and foot end lift handles. Follow Proper lifting
techniques (page 12). Avoiding any obstructions, carry the chair slowly down the stairs.
A A p p p p l l y y i i n n g g o o r r r r e e l l e e a a s s i i n n g g a a w w h h e e e e l l l l o o c c k k
W W A A R R N N I I N N G G
• Do not apply a wheel lock when an occupant is on the product or when you move the product to avoid the risk of tipping.
• Do not install or apply a wheel lock on a product with worn wheels that are less than 6 in. diameter.
• Do not leave an occupant unattended. Hold the product while an occupant is on the product.
To apply a wheel lock, press down on the pedal until it stops and is resting against the surface of the wheel.
To release a wheel lock, press down on the top of the pedal with your foot or lift up on the pedal with your toe. The top of the
pedal will rest against the caster frame when you release the wheel lock.
N N o o t t e e - - Wheel locks help prevent the product from rolling while unattended. Wheel locks may not provide sufficient
resistance on all surfaces or under loads.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e l l o o c c k k i i n n g g r r e e a a r r l l i i f f t t h h a a n n d d l l e e s s
You can use the locking rear lift handles to tip the chair back.
W W A A R R N N I I N N G G - - Always lock the lift handles in position before you use the handles to tip the chair back.
To raise the locking rear lift handles, rotate the handles up until they lock in position.
To lower the locking rear lift handles:
1. Lift up on the locking rear lift handle (A) (Figure 7).
2. Pull the red handle trigger (B) toward you with your thumb.
3. Fold the locking rear lift handle down against the chair frame.
EN 14 6252-009-005 Rev F.1