Herunterladen Inhalt Inhalt Diese Seite drucken

Protezione Termica - Micronix CB SM1208 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Descrizione del programma di carica
Carica a 14,4 Volt - 0,8 Amp
Adatta per le batterie di capacità compresa tra 1,2 - 35Ah: es.
motocicli.
La carica segue un ciclo IUoUp con 3 fasi a commutazione
automatica. Fig.2
FASE 1
Carica con la corrente massima fino a portare la tensione della
batteria sopra i 14,4V (spia "B" accesa). In questa fase la
batteria viene portata a circa 80% della sua carica.
FASE 2
Carica a tensione costante fino a che la corrente erogata
raggiunge il valore di 0,4A (spia "B" accesa).
Se la carica dura più di 18 ore il caricabatterie passa alla fase
successiva per evitare di danneggiare batterie difettose.
FASE 3
Fine della carica e passaggio allo stato di controllo della batteria
(spia "C" accesa). Una volta che la batteria è stata caricata, il
caricabatterie controlla la tensione della batteria. Se la tensione
scende sotto i 12,8V, passa alla fase 1.
Il caricabatterie può essere tenuto collegato per diversi
mesi. Se dovesse venire meno l'alimentazione, al suo
ripristino riprende automaticamente la carica prescelta.
Non lasciare la batteria incustodita per lunghi periodi.
Il caricabatterie non è in grado di iniziare la carica se una
batteria da 12V eroga una tensione inferiore a 6V (batteria
estremamente scarica).

Protezione termica

Il caricabatterie è dotato di un protettore termico che riduce
gradualmente la corrente erogata, quando la temperatura interna
raggiunge valori troppo elevati.
Smaltimento
Avviare ad un riciclaggio rispettoso dell'ambiente gli imballaggi,
i prodotti e gli accessori dismessi.
Solo per i Paesi della CE:
Non gettare i prodotti dismessi fra i rifiuti domestici !
Conformemente alle prescrizioni della direttiva 2002/96/CE sui
rifiuti delle apparecchiature elettriche ed elettroniche (RAEE)
ed all'attuazione del recepimento nel diritto nazionale, i prodotti
diventati inservibili devono essere raccolti separatamente ed
inviati ad una riutilizzazione ecologica.
Instruction manual
Automatic battery charger
Overview and warnings
Carefully read this manual, and both the instructions provided
with the battery and the vehicle in which it will be used before
charging.
EN
 Make sure that the power supply socket to which the battery
charger is connected is protected by safety devices (fuses
or automatic circuit breaker).
 Never use the battery charger with damaged cables or
whenever the charger has been subjected to impact or
damaged.
WARNING: EXPLOSIVE GAS!
 Batteries generate explosive gas (hydrogen) during normal
operation and even greater quantities during recharging.
 Avoid creating flames or sparks.
 The battery charger itself can generate sparks. Make sure
that the clamps cannot be accidentally released from the
battery's poles.
 Make sure that the plug is unplugged from the socket before
connecting or disconnecting the cable clamps.
 Never let the cable clamps touch each other.
 Provide adequate ventilation during charging.
 Whenever permitted by the type of battery, remove the caps
and check the level of the electrolyte in the cells, adding
distilled water if necessary. Make sure that the electrolyte
level is 5-10 mm over the battery's cells.
 Charge the battery with the electrolyte caps in place. Many
batteries have flame retardant caps. Place a damp cloth over
electrolyte caps that are not flame retardant.
 Carefully read the recharging instructions provided by the
Manufacturer for maintenance -free batteries.
 Never open the electrolyte caps in maintenance-free
batteries.
 Some maintenance-free batteries have level indicators.
Whenever the acid level is indicated as being too low, the
battery must be replaced. Never attempt to recharge such
batteries.
 Never charge frozen batteries that might explode.
 Never attempt to charge batteries that cannot be recharged
or other types than those indicated.
 Always wear safety goggles closed at the sides, acid-proof
safety gloves, and acid-proof clothing.
 Never position your face close to the battery.
 Position the battery charger as far as possible from the
battery
 Never let acid drip onto the battery charger, cables or
clamps.
Additional warnings
 Never position the battery charger on flammable surfaces.
 Never place the battery charger and its cables in the water
or on wet surfaces.
 Position the battery charger with adequate ventilation; never
cover it with other objects or close it inside containers or
closed shelves.
Warnings for batteries in vehicles
 Maintain a safe distance from all moving parts, such as fans,
transmission belts and pulleys.
 Maintain a safe distance from all heated surfaces such as
engines and cooling systems to avoid burns.
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis