Synchronizing With Digital Devices; Using The Word Clock Of An External Device As The Master Clock; Making Connections To Use An Optical Out (S/Mux) Of This Unit As The Clock Master - Tascam 8p Dyna SERIE Bedienungsanleitung

Synchronizing with digital devices

Using an OPTICAL OUT (S/MUX) of this unit
as the clock source master
The signal output from an OPTICAL OUT (S/MUX) connector of
this unit can be used as the master clock to synchronize with
connected devices.
Use the sample clock switch (9) to set the sample clock, causing
the corresponding indicator (e) to light. (see "Switching the
sample clock" on page 12)
Using the word clock of this unit as the clock
master
The signal output from the WORD OUT connector of this unit
can be used as the master clock to synchronize connected
devices.
Set the connected device to accept external clock input.
Using the word clock of an external device as
the master clock
The signal input through the WORD IN connector of this unit
can be used as the master clock to synchronize with connected
devices.
Use the sample clock switch (9) to set the source to EXT. (see
"Switching the sample clock" on page 12)
Making connections to use an OPTICAL OUT
(S/MUX) of this unit as the clock master
This connection method is also suitable for other audio
interfaces with OPTICAL IN connectors.
44.1/48kHz sampling frequency connection
examples
TASCAM SERIES 8p Dyna
TASCAM SERIES 102i
Connecting this unit with a SERIES 102i
TASCAM SERIES 8p Dyna
TASCAM SERIES 208i
Connecting this unit with a SERIES 208i
Cable connections
o Use an optical cable to connect an OPTICAL OUT (S/
MUX) connector of this unit to an OPTICAL IN (S/MUX)
connector of a TASCAM SERIES 102i/208i. Use one optical
cable to connect to either the A or B connector.
Setting the sample clock source
o Use the sample clock switch to set the clock source of this
unit. (see "Switching the sample clock" on page 12)
o To set the clock source of the TASCAM SERIES 102i/208i,
set the Settings Panel INFORMATION screen Sample Clock
Source item to "OPTICAL A" or "OPTICAL B" (SERIES 208i
only).
When the sample frequency is 88.2/96kHz (S/
MUX2) or 176.4/192kHz (S/MUX4)
TASCAM SERIES 8p Dyna
TASCAM SERIES 208i
Cable connections
o Use 2 optical cables to connect the OPTICAL OUT (S/
MUX) connectors of this unit to the OPTICAL IN (S/MUX)
connectors of a TASCAM SERIES 208i.
Setting the sample clock source
o Use the sample clock switch to set the clock source of this
unit. (see "Switching the sample clock" on page 12)
o To set the clock source of the TASCAM SERIES 208i, set the
Settings Panel INFORMATION screen Sample Clock Source
item to "OPTICAL A" or "OPTICAL B".
13
TASCAM SERIES 8p Dyna