Installation - Renogy ROVER PG Serie Installation Und Handbuch

Recommended tools to have before installation:
Connect battery terminal wires to the charge controller FIRST then connect the
WARNING
solar panel(s) to the charge controller. NEVER connect solar panel to charge
controller before the battery.
Do NOT connect any inverters or battery chargers into the LOAD TERMINAL of
WARNING
the charge controller.
Do not over tighten the screw terminals. This could potentially break the
CAUTION
piece that holds the wire to the charge controller.
Refer to the technical specifications for max wire sizes on the controller and
CAUTION
for the maximum amperage going through wires.
You are now ready to begin connecting your battery to your charge controller.
EN

Installation

Screwdriver Multi-Meter
INVERTER
BATTERY
CHARGER
HIGH AMP
DRAWING DEVICE
10