Devon Tread 1 Gebrauchsanweisung Seite 16

C L E a n i n g
With the exclusive case design of the Tread 1,
careful cleaning methods must be considered when
caring for your watch. The Tread 1 should never be
submerged in water or any cleaning solution. Steam
cleaning and high-pressure compressed air should
also be avoided when cleaning the Tread 1.
For light cleaning, gently wipe the surfaces of the
Tread 1 with a soft, non-abrasive, lint-free cloth to
remove any loose dirt and dust.
For a heavier cleaning, start by using a jeweler's
blower to remove loose dust and debris from the
surface of your watch. Lightly loosen caked-on
debris with a soft brush or other small, soft tool.
Blow away the particles with the jeweler's blower.
Dampen a non-abrasive cloth, and then wring out as
much water as possible. Rub the cloth gently over
the watch face and case.
If a stronger cleaning agent is needed, isopropyl or
rubbing alcohol may be used. For isopropyl alcohol,
use four parts alcohol to one part water. Dampen a
non-abrasive cloth in the solution, and then wring
out as much solution as possible. Rub the cloth
gently over the watch face and case.
For cleaning within the crevices of the Tread 1, dip
a cotton swab in water or the isopropyl alcohol
solution. Rub off as much moisture from the tip