Temperature Display; Led Torch - Powerfix Profi 109791-14-01 Bedienungs- Und Sicherheitshinweise

Push the ON / SET button
device on.
Before making the first measurement, use a test aid
to verify the device is working properly. The
1
test aid has four measuring points marked B and T.
Push the measuring pins
B. All gauge marks in the display
gin to flash.
Now press the measuring pins into measuring
points T. The gauge marks in the display should
read 19 % (+ / - 1 %).
The device is ready for use if both tests return
the specified values.
Push the measuring pins into the material you
wish to test. The gauge marks in the display
will show the moisture content.
-symbol, left: use to read the measurement
for firewood, cardboard and construction wood.
-symbol, right: use to read the measurement
of mortar, concrete and plaster.
Note: the gauge marks will start flashing if
the measurement exceeds the maximum values
of 2 % resp. 44 %.
Note: perform comparison measurements in
several different locations to minimize measur-
ing errors.

Temperature display

Note: the temperature will be displayed in the top
section of the display
Hold the ON / SET button
switch between Celsius (°C) and Fahrenheit (°F).

LED torch

Hold the LED button
switch on the LED torch
10 GB
to switch the
4
into measuring point
2
.
3
for three seconds to
4
for three seconds to
5
.
6
will be-
3