Temperature Display; Led Torch; Auto Shut-Off - Powerfix Profi HG00730 Bedienungs- Und Sicherheitshinweise

Push the measuring pins
B. All gauge marks in the display
gin to flash.
Now press the measuring pins into measuring
points T. The gauge marks in the display should
read 19 % (+ / - 1 %).
The device is ready for use if both tests return
the specified values.
Push the measuring pins into the material you
wish to test. The gauge marks in the display
will show the moisture content.
-symbol, left: use to read the measurement
for firewood, cardboard and construction wood.
-symbol, right: use to read the measurement
of mortar, concrete and plaster.
Note: the gauge marks will start flashing if
the measurement exceeds the maximum values
of 2 % resp. 44 %.
Note: perform comparison measurements in
several different locations to minimize measur-
ing errors.

Temperature display

Note: the temperature will be displayed in the top
section of the display
Hold the ON / SET button
switch between Celsius (°C) and Fahrenheit (°F).

LED torch

Hold the LED button
switch on the LED torch
Press the LED button again to switch off the
LED torch.

Auto shut-off

The device automatically switches off if no buttons
are activated for approx. 30 seconds. The auto shut-
off is deactivated so long as the LED torch
into measuring point
2
.
3
for three seconds to
4
for three seconds to
5
.
6
will be-
3
is on.
6
GB 11