AEG S73000DSW0 Benutzerinformation Seite 32

32
Installation
2. Slide the top door off the pin (G). Un-
screw the pin (G) and install it on the
opposite side.
3. Remove the two plugs from the middle
crossbeam and install them on the op-
posite side, covering the holes left free
from the removed hinge.
4. Remove the plugs (1) on the upper side
of both doors and move them to the
other side.
5. Remove with a tool the cover (e), un-
screw the lower hinge pivot (f) using a
10 mm spanner and re-screw it on the
opposite side.
6. Install the cover (e) on the opposite side.
7. Install the top door on the pin (G). In-
sert the pivot of the middle hinge (H)
into the hole of the top door. Make
sure that the plastic space is placed un-
der the hinge. Install the bottom door
on the lower hinge pivot (f). Slightly tilt-
ing the doors insert the pivot of the mid-
dle hinge (H) into the hole of the bot-
tom door.
8. Keeping the doors open, tighten the middle hinge with two screws.
1
e
2
1
f
4
G
5
3