Technical Data; Installation - AEG S73000DSW0 Benutzerinformation

TECHNICAL DATA

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Location
The appliance should be installed well away from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabi-
net. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and the wall unit must
be at least 100 mm . Ideally, however, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by one or more adjustable feet at the
base of the cabinet.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
1600 mm
600 mm
645 mm
25 h
Ambient temperature
29
Technical data