ZAMEL VP-808B Bedienungsanleitung Seite 35

Item System functions
AUTO CAPTURE
11 01; 02; 03
QUANTITY
ENABLED
AUTO LEAVING
12
MESSAGE
DISABLED
13 SCREENSAVER TIME
14 FIRMWARE VERSION
DVR (DIGITAL VIDEO RECORDER)
Touch to open the Main Menu. Touch the DVR icon. Touch
DVR Settings.
Automatic DVR operation:
Set DVR to Enable in the System Settings. DVR can record video sequences from
each entrance panel and CCTV camera connected to the video entry phone
system.
If motion detection is enabled, the system will automatically record a video
sequence up to 7 minutes long in a cycle mode. The cycles of video sequence
recording are 1 minute + 1 minute + 5 minutes. If a camera detects movement in its
field of view, its video feed will be recorded for 1 minute. Next, the video feed is
scanned for motion again. If there is no motion detected, the video feed recording
stops. If there is motion detected, the video feed is recorded for 1 minute again.
Next, the video feed is scanned for motion again. If there is no motion detected, the
video feed recording stops. If there is motion detected, the video feed is recorded
for 5 minutes and the recording stops afterwards.
DVR will not work if the microSD card in the display has less than 2 GB of capacity.
Options Notes
Automatically captures 1, 2 or 3 video feed
snapshots during a call from an entrance
panel.
The visitor calling with an entrance panel
can leave a voice message after an
Out-of-Home Reply and tone.
Disables this mode.
30 s, 1-3 min, 5, 10, 20, 30, 40, 50, 60 min
Displays the version of the firmware installed
on the display.
14
to open the