Before Initial Use; Boiling Water; Cleaning And Maintenance - Marta MT-1091 Bedienungsanleitung

BEFORE INITIAL USE


Remove all packaging materials.

Fill kettle to the MAX line and bring to a boil. When the unit completes the boiling cycle, discard the water - repeat the process 2 to 3 times. This will remove any dust or residue remaining from the
manufacturing process.

BOILING WATER

1. Remove the unit from base.
2. Open the cover by depressing the button near the handle.
3. Fill the kettle with your desired amount of water. Do not fill above the MAX line.
4. Close the lid by pressing down gently until it locks (clicks) into place.
5. Place the kettle on base, ensuring that it is correctly engaged.
6. Connect cord to power outlet and switch unit ON; the power indicator lights up.
7. The kettle will switch off automatically when water has come to a boil.
After use, unplug and empty unused water. Ensure kettle is switched off before removing from base. Heating can be stopped at any time by the operating the switch.
As a safety feature, the unit may not start immediately after shutting off. Please allow 15 to 20 seconds for kettle to cool down before switching on again.
If kettle ever boils dry, please wait 15 minutes for unit to cool before refilling with cold water. The safety cut-off will automatically reset during this time.
Do not open lid when in operation. Steam escaping from the spout is hot. This appliance is only suitable for heating water; do not use any other liquids.
A minimum of 0.75L of water must be used to prevent overheating.

CLEANING AND MAINTENANCE

CLEANING

Unplug unit before cleaning and allow unit to cool down.

Wipe the exterior of kettle with a soft cloth. Do not use abrasive scouring pads or cleaning powders as they may scratch the surface.

Due to scale build up, it is best to de-scale your kettle weekly. It is recommended to use Citric Acid for de-scaling. If Citric Acid is not available, you can use the juice of 1 lemon. Fill kettle halfway with
Citric Acid/lemon and water mixture. Allow the unit to boil the solution two to three times. Rinse clean and wipe with a soft cloth.
6
MT-1091