Horizon Hobby Hangar 9 Carbon Cub FX-3 Bedienungsanleitung Seite 15

82. Pass the cable through the hole in the cable fi tting.
83. Slide the cable back through the sleeve.
84. Use crimping pliers to secure the sleeve to the cable.
85. Attach both rudder cables to the fi ttings.
86. Attach the rudder servo arm to the rudder servo using the
hardware included with the servo. Slide the cables into the
tubes in the fuselage. The radio system should be on and the
rudder servo centered for the following steps.
 Install both sides of the cable at the same time.
This will result in equal tension on both cables.
Carbon Cub FX-3
87. Slide a sleeve on the cable, slide the cable through the fi tting,
then back through the sleeve. Lightly tension the cables, then
use crimping pliers to secure the sleeve to the cables. Use
side cutters to remove any excess cable.
 The rudder cables may stretch slightly over
time. Periodically check the cables to make
sure there is still light tension on them.
15 EN