Comet DSG-8 EX Bedienungsanleitung Seite 12

found, do not use the appliance but contact
your service centre for repair.
12 Do not use the appliance for steam clea-
ning electrical appliances or electric sockets.
13 Once the appliance is plugged in, do not
work with wet hands or feet.
14 Do not immerse the appliance in any liquid.
Do not steam-clean the appliance.
15
Service and repairs must be carried out by
16
qualified personnel only. Only use manufactu-
rer original spare parts for service repair.
17 Before connecting the appliance, make
sure that the nameplate data are the same as
those of the electrical mains .
17c The electric supply connection shall be
made by a qualified electrician and comply
with IEC 60364-1. It is recommended that the
electric supply of this machine should include
either a residual current device that can inter-
rupt the supply if the leakage current to earth
exceeds 30 mA for 30 ms or a device which can
test the earth circuit..
18 Ensure that power sockets used ore correct
for the machine.
20 The electric cable must be replaced only by
an authorised service centre.
Do not put your hands close to the steam
25
jet.
26 Never obstruct the steam outlet.
Do not point the steam jet towards people
27
or animals.
28 During use the appliance could overheat if
covered.
29 If the appliance is lent to someone else, the
instruction manual should also be passed on.
This appliance is not intended for use by per-
16i
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experi-
ence and knowledge.
Children should be supervised to ensure that
17i
they do not play with the appliance.
04i This appliance has been designed for use with
the detergent provided or the detergent speci-
fied by the manufacturer, such as a neutral sham-
poo based on biodegradable anionic surface ac-
tive detergents. The use of other detergents or
chemicals may put the appliance's safety at risk.
Do not direct the jet against yourself or others
23i
in order to clean clothes or foot-wear.
21i Risk of explosion — Do not spray flammable
liquids.
08i High pressure hoses, fittings and couplings
are important for the safety of the machine. Use
only hoses, fittings and couplings recommended
by the manufacturer. (it is extremely important
to protect these components against damage by
avoiding their improper use and protecting them
against bending, knocks and scratches).
To ensure machine safety, use only original
22i
spare parts from the manufacturer or approved
by the manufacturer.
ADDITIONAL RISKS
In order to work in the maximum safety conditions
and to avoid any dangerous situation and acci-
dent, the operator must follow the operating in-
structions and regulations listed below.
- If the machine must be disarmed immediately for
any reason whatsoever, turn the main switch to
the OFF position.
- During the machine functioning, it is strictly for-
bidden to remove the safety devices assembled
by the builder on the machine in order to protect
the operator while performing his tasks.
- Only skilled and qualified operators can use the
machine.
- Never leave the machine unattended.
- To work, the machine requires only one operator.
It is obbligatory to wear protective gloves
when using the machine.
It is obbligatory to wear protective goggles
when using the machine.
WARNING ABOUT THE ADDITIONAL
The following warning plates are applied to the ma-
chine:
CAUTION! It is important to be care-
WARNING Danger from hot steam.
WARNING Danger of scalding
Danger from hot steam.
12
RISKS
ful of the following items.
WARNING: High pressure
jets can be dangerous if
subject to misuse. The jet