Safety Regulations - EINHELL TE-RS 40 E Originalbetriebsanleitung

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Fig. 1/2/3)
1 Grinding/sanding disk
2 Handle
3 Speed controller
4 Operating switch
5 Connection for dust collection box
6 Dust collection box
7 Additional handle
8 Clamping screw
9 Locking knob
2.2 Items supplied
Please check that the article is complete as spe-
cifi ed in the scope of delivery. If parts are missing,
please contact our service center or the nearest
branch of the DIY store where you made your
purchase at the latest within 5 work days after
purchasing the article and upon presentation of
a valid bill of purchase. Also, refer to the warranty
table in the warranty provisions at the end of the
operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
Anl_TE_RS_40_E_SPK9.indb 15 Anl_TE_RS_40_E_SPK9.indb 15
GB
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
•
Safety instructions
3. Proper use
The machine is designed for the grinding/san-
ding of wood, metal, plastic and similar materials
using the appropriate grinding/sanding paper.
The equipment is not suitable for wet grinding/
sanding.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Voltage ........................................... 230 V ~ 50 Hz
Power input ................................................ 400 W
Grinding/sanding area .........................Ø 125 mm
Abrasive paper size .............................Ø 125 mm
Idling speed ............................6,000-12,000 min
Oscillating speed ..................12,000-24,000 min
Oscillatory circuit ..................................... 2.5 mm
Protection class: ............................................ II/
Weight: .......................................................2.1 kg
- 15 -
-1
-1
31.10.2019 09:22:19 31.10.2019 09:22:19