Problem Solving - CME Toptel 2 200 Gebrauchsanleitung

PROBLEM
The appliance does not respond and the TV - SAT -
TER selection buttons do not light up when a button is
pressed.
The appliance does not respond but the selection
buttons light up.
The selection buttons fl ash.
The remote control is not carrying out all the commands
properly.
The code for your appliance brand is not in the list of
codes at the end of this booklet.
If you have any queries about your remote control:
• read this Instruction Booklet carefully, which will provide an answer to most of your questions
• consult the website www.cme.it where you can quickly and easily fi nd all the answers you need.
In case of need, you can write to customer assistance at telecomandi@cme.it. Enter the important information
regarding your appliances in the table below and have this information ready in order to help us assist you more
quickly:
Model of CME remote control: _______________ (see body of remote control)
Make of appliance Type
es: THOMSON TV
2-year WARRANTY
The warranty ceases to be valid if the product
is tampered with or used incorrectly.
Purchase date
The symbol of a bin crossed out on the appliance indicates that the product at the end of its life cycle should be disposed of separately
from other refuse. The user will, therefore, have to hand over the appliance at the end of its life cycle to a proper recycling centre for
electronic and electrotechnical refuse, or give it over to the seller each time a new, similar appliance is purchased. Proper separate
refuse collecting for the later initiation of the appliance sent for recycling, treatment and environmentally friendly disposal, contributes to
reducing negative effects on the environment and on our health and encourages the recycling of the material used to make it.
10

PROBLEM SOLVING

SOLUTION
Try some of the other frequently-used buttons. If the
problem persists, check that the batteries are fi tted
correctly. If necessary, replace them with 2 new 1.5 V
AAA/LR03 batteries.
Check that the batteries are new and that the remote
control is pointing at the appliance without any obstacles
in the way. If necessary, reset the remote control code,
repeating the programming procedure.
The batteries are low. Change them.
Perhaps you are using an incorrect code. Reset
the remote control by repeating the programming
procedure.
Perform the programming procedure using the brand
replacement code 0099. Alternatively, consult the on-
line guide at www.cme.it in order to fi nd the appliance
code with which to programme your remote control.
INFO-LINE
Model Mod. original remote control
25DU78M
Dealer's stamp
RCT 4000
Brand code
1007