Starting Operation - stayer BHL112BK Bedienungsanleitung

Certain dusts, such as oak or beech dust, are
considered as carcino genic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Pro v ide for good ventilation of the work-
ing place.
– It i s recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation

Starting Operation

Inserting the Battery
f Use only original Stayer lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Not aply to 202-204 models:
Set the rotational direction switch 7 to the cen-
tre position in order to avoid unintentional start-
ing. Insert the charged battery 5 into the handle
so that it can be felt to engage and faces flush
against the handle.
Reversing the Rotational Direction
The rotational direction switch 7 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 8 actuated.
Right Rotation: For drilling and driving in
screws, push the rotati onal direction switch 7
left to the stop.
Setting the Torque / Setting the Operating
Mode
The required torque can be preselected in 16
steps with the torque preselection ring 3. With
the correct setting, the insert tool is stopped as
soon as the screw is screwed flush into the ma-
terial or when the set torque is reached.
Select a higher setting when driving out screws,
or set to the symbol "Drilling".
Drilling
Set the preselection ring 3 to the "Drilling with-
out impact" symbol.
ENGLISH
22
The safety clutch is deactivated in the "Drilling"
position.
Impact drilling
Set the preselection ring 3 to the "Im-
pact drilling" symbol.
In the "Impact drilling" position, the safety
clutch is deactivated and the maximum power is
always effective.
Gear Selection, Mechanical
f Actuate the gear selector 4 only when the
machine is at a standstill.
Two speed ranges can be preselected with the
gear selector 4.
Gear I:
Low speed range; for screwdriving or working
with large drilling diameter.
Gear II:
High speed range; for working with small drilling
diameter.
If the gear selector 4 cannot be fully engaged,
lightly rotate the drive spindle with the drill bit
by twisting the drill chuck.
Switching On and Off
To start the machine, press the On/Off switch
8 and keep it pressed.
The light 6 is lit when the On/Off switch 8 is
slightly or completely pressed in and permits to
light the work area when the lighting conditions
are bad.
To switch off the machine, release the On/Off
switch 8
Start In / Out PBL202BL / PBL204BL
- Keep the tool in a natural way, with the index
finger on the touch panel forward 7 and the middle
finger in the reverse touch panel 8.
- Lightly press the buttons simultaneously tactile 7-
8. Both LED work light and remaining power
indicator will illuminate for a few seconds.
- Release your fingers forward reverse pads 7 and
8. The last 5 min tool enters a sleep mode, to
disable it you must push two soft buttons 7- 8 and
thus ready for use.
- The buttons are pressure sensitive in accordance
with the pressure rate 7 or 8 must be set within the
tool.
22
(PBL181PK - PBL1820PK
PBL182PK - PBL184PK)