Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Avoiding Mould And Unpleasant Odours - Indesit SAN 400 Gebrauchsanleitung

Maintenance and care

Switching the appliance off

GB
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
It is not sufficient to set the temperature adjustment knobs
on (appliance off) to eliminate all electrical contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber
seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
• The removable accessories may be soaked in warm
water and soap or dishwashing liquid. Rinse and dry
them carefully.
• The back of the appliance may collect dust which can
be removed by delicately using the hose of a vacuum
cleaner set on medium power. The appliance must be
switched off and the plug must be pulled out before
cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic materials
which are odour free. In order to maintain an odour free
refrigerator and to prevent the formation of stains, food
must always be covered or sealed properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the door open.
14

Defrosting the appliance

! Follow the instructions below.
Do not speed up the defrosting process by using any tools
or electrical devices, you may damage the refrigeration
circuit.
can flow out easily.

Replacing the light bulb

To replace the light bulb in the refrigerator compartment,
pull out the plug from the electrical socket. Follow the
instructions below.
Access the light bulb by removing the cover as indicated in
the diagram.
Replace it with a similar light bulb within the power range
indicated on the cover (15W or 25W).
1
2
The refrigerator has an
automatic defrosting
function: water is ducted to
the back of the appliance
by a special discharge
outlet (see diagram) where
the heat produced by the
compressor causes it to
evaporate. It is necessary
to clean the discharge hole
regularly so that the water
1