Inhaltsverzeichnis
Werbung
placing the top part in the corresponding housing and allowing it
GB
to drop in again.
5. When the ice has formed (minimum time approximately 8 hours)
knock the tray against a hard surface and wet the outside so
that the ice cubes come loose and take them out through the
opening.
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect the
appliance from the electricity supply.
It is not sufficient to set the temperature adjustment knobs on
(appliance off) to eliminate all electrical contact.
Cleaning the appliance
• The external and internal parts, as well as the rubber seals may
be cleaned using a sponge that has been soaked in lukewarm
water and bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water and
soap or dishwashing liquid. Rinse and dry them carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner set
on medium power. The appliance must be switched off and the
plug must be pulled out before cleaning the appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which are
odour free. In order to maintain an odour free refrigerator and to
prevent the formation of stains, food must always be covered or
sealed properly.
• If you want to switch the appliance off for an extended period of
time, clean the inside and leave the doors open.
Defrosting the appliance
! Follow the instructions below.
Do not speed up the defrosting process by using any devices or
tools other than the scraper provided, you may damage the
refrigeration circuit.
Defrosting the refrigerator compartment
The refrigerator has an automatic defrosting function: water is
ducted to the back of the appliance by a special discharge outlet
( see diagram ) where the heat produced by the compressor
causes it to evaporate. It is necessary to clean the discharge hole
22
All manuals and user guides at all-guides.com
regularly so that the water can flow out easily.
MAX
WATER LEVEL
Defrosting the freezer compartment
If the frost layer is greater than 5 mm, it is necessary to defrost
manually:
1. Set the TEMPERATURE ADJUSTMENT knob to the position
2. Wrap frozen foods in newspaper and place them in another
3. Leave the door open until the frost has melted completely. This
4. Clean and dry the freezer compartment carefully before
5. Certain appliances are fitted with the DRAIN SYSTEM to lead the
6. Wait for approximately 2 hours, i.e. until the ideal storage
Replacing the light bulb
To replace the light bulb in the refrigerator compartment, pull out
the plug from the electrical socket. Follow the instructions below.
Access the light bulb by removing the cover as indicated in the
diagram. Replace it with a similar light bulb within the power range
indicated on the cover (15W or 25W).
PURE WIND PLUS*
Filter maintenance
Unhook the filters from the left side of the cover by inserting the tip
of a small screwdriver into the gaps (see attached pictures).
Wash the filters regularly (every 12-18 months) under running
water, using a neutral detergent to remove any stubborn build-up.
Leave the filters to dry before replacing them. If the filters cannot be
removed, or if they are difficult to remove, please contact the
Technical Assistance Service.
freezer or in a cool place.
can be made easier by placing containers with lukewarm water
in the freezer compartment.
switching the appliance on again.
water outside: let the water flow into a container ( see diagram ).
conditions have been restored, before placing food in the
freezer compartment.
1
2
.
1
Werbung
Inhaltsverzeichnis
Fehlerbehebung
