Troubleshooting; Assistance - Indesit SAN 400 Gebrauchsanleitung

Troubleshooting

Assistance

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.
GB
Malfunctions:
The internal light does not illuminate.
The refrigerator do not cool well.
The food inside the refrigerator is
beginning to freeze.
The AIR fan does not rotate.
The motor runs continuously.
The appliance makes a lot of noise.
The back wall of the refrigerator unit is
covered in frost or droplets of water
There is water at the bottom of the
refrigerator.
Assistance
Before calling for Assistance:
• Check if the malfunction can be solved on your own (see Troubleshooting).
• If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service Centre
Communicating:
• type of malfunction
• appliance model (Mod.)
• serial number (S/N)
This information can be found on the data plate located on
the bottom left side of the refrigerator compartment.
Never call on unauthorized technicians and always refuse spare parts which are not originals.
16
Possible causes / Solutions:
• The plug has not been inserted into the electrical socket, or not far enough
to make contact, or there is no power in the house.
• The TEMPERATURE CONTROL Knob is on
• The door do not close properly or the seals are damaged.
• The door are opened too frequently.
• The TEMPERATURE ADJUSTMENT knob is not in the correct position
• The refrigerator have been over-filled.
• The TEMPERATURE ADJUSTMENT knob is not in the correct position.
• The food is in contact with the back inside wall of the refrigerator.
• The refrigerator door is open.
• The AIR system is only activated automatically when it becomes necessary
to restore perfect operational conditions inside the refrigerator compartment.
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The appliance has not been installed on a level surface (see Installation).
• The appliance has been installed between cabinets that vibrate and make
noise.
• The internal refrigerant makes a slight noise even when the compressor is
off. This is not a defect, it is normal.
• This shows the appliance is operating normally.
• The water discharge hole is blocked (see Maintenance).
195057919.02
10/2007
setting.
serial number model